A new Linux server is available to support laptop operation starting on 2\/24\/2014.
\nThese are the necessary steps to set up the server.<\/p>\n
1. Install Fedora Core 11 (disc 942) since the hardware platform is not suitable for cpu-intensive tasks such as ffmpeg. This is an old Celeron with limited memory capacity (only 448 MB with 320 GB hard disk).<\/p>\n
2. Change \/etc\/inittab to run in multi-user console mode.
\n # Default runlevel. The runlevels used are:
\n # 0 – halt (Do NOT set initdefault to this)
\n # 1 – Single user mode
\n # 2 – Multiuser, without NFS (The same as 3, if you do not have networking)
\n # 3 – Full multiuser mode
\n # 4 – unused
\n # 5 – X11
\n # 6 – reboot (Do NOT set initdefault to this)
\nid:3:initdefault:<\/p>\n
3. Assign static IP address (Brianna at .118). Check adapter address on Angelina (.108).
\n\/etc\/rc.local
\nifconfig eth0 xxx.xxx.xxx.118 netmask 255.255.255.0 up<\/p>\n
4. Disable SELinux policy in \/etc\/selinux\/config
\nSELINUX=disabled<\/p>\n
5. Set up SMB for Windows access.
\nyum install samba
\nModify the following lines at \/etc\/samba\/smb.conf
\n workgroup = Linux
\n server string = Brianna 1.0 GHz Celeron
\n hosts allow = 192.168.224.
\n[documents]
\n path = \/home\/xxxx\/Documents
\n writeable = yes
\n browseable = yes
\n valid users = xxxx<\/p>\n
6. Set up SSH on Angelina for console access.
\n7. Yum install httpd (use ClearSpot USB access).
\nyum install httpd
\nyum install httpd-devel<\/p>\n
8. Set up the MySQL 5 databas\u1eb9
\nyum install mysql
\nyum install mysql-devel<\/p>\n
9. Set up php 5.2 package.
\nyum install php<\/p>\n
10. Set up GIMP graphic package.
\nyum install gimp<\/p>\n
11. Change the behavior of the console prompt at \/root\/ and ~
\ncat .bash_profile
\nPATH=$PATH:$HOME\/bin
\nexport PATH
\nexport HISTSIZE=10000
\nexport HISTCONTROL=erasedups
\nshopt -s histappend
\nPATH=$PATH:\/sbin:\/usr\/sbin
\nPS1=’! u w % ‘<\/p>\n","protected":false},"excerpt":{"rendered":"
A new Linux server is available to support laptop operation starting on 2\/24\/2014. These are the necessary steps to set up the server. 1. Install Fedora Core 11 (disc 942) since the hardware platform is not suitable for cpu-intensive tasks … \u0110\u1ecdc ti\u1ebfp